How To Repair Concrete After Removing Tack Strips

If y'all don't like tack stripes left on the edges of your room, so you must know how to remove carpet tack strips. The strips of metallic tacks under your rug and rug padding are referred to as tack strips.

Discarding old rugs may be essential to save labor expenses if yous are having your carpet replaced. You may likewise want to remove your mat if you have hardwood floorings under your carpet that you would similar to apply a new coating on.

If yous want to install a new carpet, you do non have to discard the tack strips; yous can use them once more to hold the new carpet. If y'all want to refinish the hardwood floors underneath your carpet or intend to tile the surface, you have to remove the tack strips.

After removing your rug, y'all will nearly probably take tack strips left around the edge of the room. Extracting these tack strips that in one case gripped your rug is the well-nigh ho-hum aspect of rug removal.

To remove rug tack strips, slip a wide putty knife between the tack strip and the flooring beside the nail head, then put in a pry bar under the putty knife. Slam the other end of the pry bar softly with a hammer as this pulls out the smash from the floor.

How to Remove Carpet Tack Strips

Items Needed

Work gloves
Utility knife
Hammer
Boots
Painter's tool
Pry bar
Carpet staple remover
Gloves (optional)
Broom or vacuum
Trash bag
Sturdy clothes

Procedure

Put on eye protection, thick piece of work wearing apparel, gloves, and boots before yous commencement removing tack strips. Find a nail caput on top of the tack strip.

If the old rug was installed over a hardwood floor that you lot at present want to renew, sideslip a wide putty knife between the tack strip and the floor beside the smash head, and so put in a pry bar under the putty pocketknife.

Suppose a floor is nether the old rug that you intend to cover once again with a new carpet set in the pry bar directly under the tack strip.

You can use the utility knife to cut the rug into easy strips, which you will afterward curl upwards and remove. Rug textures are pretty hard, so you lot will perchance accept to brand 2 or 3 passes to cut all the mode through.

At that place is no necessity for a cautious touch unless there is a expert hardwood floor underneath that you attempt to rescue information technology from being damaged.

Slam the other end of the pry bar softly with a hammer. This should bring the nail out of the floor. If the floor is accurate, y'all might have to hit the pry bar with more than pressure.

Many pry bars are besides difficult on their prying end to effortlessly ready in between the tack strip and the flooring. Using the painter's tool, you tin can create a space, and the pry bar will fit right in.

Remove the pry bar and pull out the putty knife if you are using it. Put them in once again abreast the post-obit boom on the tack strip, and popular that nail out a like way. Start like this again until you have loosened the unabridged strip.

You have to be careful when removing carpet tack strips; those tacks are very sharp.

Related: How to become wrinkles out of carpet without a carpet stretcher

Dispose of the old tack strip in a large trash bag. Repeat the method with the other tack strips in the room. Observe the floor for devious tacks that did not pull gratuitous with the tack strips. Pull them out with the claw edge of the hammer and discard them.

Vacuum or sweep the flooring to discard whatever grit. Discarding tack strips can exit sharp bits of metal or wood behind; you can pull them and ensure that the floor is neat.

Read: Best Vacuum Cleaner Review

Conclusion

On knowing how to remove carpet tack strips, y'all shouldn't have any worries when irresolute your carpeting. Keep in mind that these strips are very sharp, ensure to accept your boots on to avoid accidents.